電熱水鍋爐http://www.nenp.com.cn/在點火前，先打開循環水泵，然后檢查循環水泵流量揚程是否是正常的。要確認水循環、排氣等沒有問題，且上壓至設定值后，才能夠點火。將自然通風門打開至一定程度后用一些易燃物引火，比如木柴等，但是不能用具有強烈揮發性的油類引火，這樣是非常危險的。
Electric water boiler before ignition, open circulating pump, circulating pump flow head and then check whether it is normal. To confirm the water cycle, exhaust, etc. is no problem, and after the pressure to the set value, it can ignite. After natural ventilation door open to a certain extent with some of the combustible ignition, such as firewood and so on, but can not use the volatile oils have a strong fire, this is very dangerous.

先開啟電熱水鍋爐引風機，然后打開鼓風機，這樣能夠避免在預熱管子時，出現變形或燒壞等現象。電熱水鍋爐點火好以后，火力應是由弱到強，逐漸加大，等到煤正常著火后，再啟動爐排，調整煤閘板的開度，并加大送風量，這樣讓煤能夠完全進行燃燒。
First open the electric hot water boiler fan, and then open the blower, this can be avoided when preheating pipe, deformed or burned and so on. After a good electric water boiler ignition, the fire should be to strong, gradually increasing from weak, normal firing until after the coal, and then start the grate, adjust the opening of the gate of the coal, and increase the air supply, so let coal can be completely combustion.

電熱水鍋爐http://www.nenp.com.cn/應按照規定要求，定期進行排污工作，排污工作，應在鍋爐壓力穩定，且負荷比較低的情況下進行，定期排污時，應按照循環回路順序進行，每一次的循環排污事件不能超過30秒。排污閥不能同時開啟兩個或多個以上，以免破壞水循環。
Under electric hot water boiler should be in accordance with the requirements of regular sewage work, sewerage work, should be in the boiler pressure is stable, and relatively low load situations, periodic sewage, shall order the circulation loop, loop sewage every event must not exceed 30 seconds. Drain valve can not open two or more of the above, in order to avoid damage to the water cycle.